8 modeli
This is a really easy print with no need for any support material. The tolerance is .125mm, which I think it's perfect. It's loose enough to easily insert and remove the remote, but tight enough that there is essentially no play when…
Introducing the WiZmote Holder, a wall mounted holder for the WiZmote . It is designed to mount to the wall with a medium 3M Command Strip (not included) for easy installation and removal. The provided G-Code is for rough estimate only…
Model has 3 slots in back where you can slide magnets during print. I used 10mm x 2mm round neodynium magnets but i assume square ones are fine too, slots are 11x2mm squares. Prints upright with no support
Easily mount turn your wizmote into a smart switch. Mounts wizmote to a standard light switch plate.
Remote Control Holder for WiZMote, WiZ remote control, wall mountable using two screws 40mm apart, two poster size command strips or magnets (either two or four 3mm x 10mm). Two desk versions also, 30 degree or 60 degree angle. Wall mount…
This replacement is slightly bigger than the original super thin back. Should still sit nearly flush with the remote. Made and tested this with a 0.6 nozzle by using perhaps poorly tuned PETG. Let me know if this feels too loose, which it…
Remote Control Holder for WiZMote, WiZ remote control, wall mountable using two screws 40mm apart, two poster size command strips or magnets (either two or four 3mm x 10mm). Two desk versions also, 30 degree or 60 degree angle. Wall mount…
