Liczymy pasujące modele…
I recently built a Lily58 keyboard from Boardsource.xyz and wanted to print a case. I found the design done by Josh and really liked it. I ran into an issue where one of the holes did not line up with a hole on the PCB. It was close, but…
Just wanted to share this easy fix. My k95 wrist rest clips broke First I tried to glue them but that didn't last long so I made these simple clips in fusion to replace them ... Just cut the remaining part of the clip about where the old…
Wristrest for the Wooting 60HE with the possibility to wrap in leather or other.
I got a new Keyboard from AKKO which is made from walnut wood. I made a new 32cm wide design for a wrist rest and printed it in coffee filament to match the style of the keyboard. Printed with 10% Infill and 3 walls standing on the build…
This design will only fit the New Model M if printed in flexible material. The wristrest matches the side profile of the board, with the rear feet extended. Print it in 3 sections even if your printer fits half the model, so the glue…
Simple wristrest for the KBD67mkII which should sit pretty flush with the case and follows the existing typing angle. It prints comes in 2 pieces with little nubs for alignment, so you'll need to epoxy or glue them together after the…
K95 keyboard, both clips broke due to wear&tear so I modeled replacements. Original part design was prone to breaking, so I improved it a bit. Printed in PLA, 0.2 layerheight and 50% infill on a Prusa Mini+ otherwise stock settings…
This wristrest fit my SKY 2040-M16 leverless controller that measures 128x210mm. If you want to check if it will fit yours without wasting all the filament, you can use the hole check model first and see if the holes line up. In my case,…
I designed this one because I got a new keycap set which looked perfect to create a “prusa wristrest". I went for sure for the hexagon design. I wanted it to be printable on most normal sized print beds. That's why I cut it in the middle.…
