Liczymy pasujące modele…
I liked the original design because of its clean surfaces and edges. I've just tweaked it a little bit and added the base for the ApexEVO frame. !IMPORTANT!{begin} The gap between the front propellers and the mount is about 6mm. I haven't…
There are two versions. The only difference between them is the extra cut-out for the recording-light above the front screen of the GoPro. Check that there is enough clearence between the camera body and the front propellers!
This is for the Happymodel EP1 and EP1-Dual antennas. As shown in the picture you can make a small cut to make inserting the antenna easier.
This design is for the Flywoo action camera case V2.1 for a naked GoPro. I've uploaded different angles. Starting from 10 degrees to 35 degrees, with 5 degree increments. To make it easier to identify the angle once printed, it is stamped…
20x20 mounting holes added and designed some arms covers (use supports to print them nicely, not as me ^^). ABS main frame, annealed and painted STPLA pod Don't really like the butterfly props but still having some sets to crash...…
