1 / 3
Hörmann remote control housing for VW T-Roc / Hörmann Fernbedienungs-Gehäuse für VW T-Roc. — image 1
1 / 3

Hörmann remote control housing for VW T-Roc / Hörmann Fernbedienungs-Gehäuse für VW T-Roc.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Housing for permanent installation of a Hörmann garage door remote control in the center console of the VW T-Roc (2018).

Rating
5 / 5
Likes
3
Downloads
29
Makes
0
Views
822
Reviews
1

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution

Since operating the remote control for my garage door hanging on my car key chain was always a bit fiddly, I wanted to install a remote control permanently in my VW T-Roc (2018). But the existing housing of the Hörmann remote control (see photo) is not very suitable for this.
I identified the small storage compartment in the center console, which I didn't use anyway, as a good place for the remote control and designed a suitable housing for the remote control circuit board.
The housing is dimensioned so that it clamps into the opening of the storage compartment without additional fastening.

The housing consists of an upper and lower part and the button, which is required twice. The two additional buttons on the right and left that are present in the original housing are not required.

To screw the upper and lower parts together, I used melting nuts for M2.5 screws in the upper part. 

Two melting nuts of size M2.5 x 3.5 x 3 are required.

-----------------------------------------------

Da das Bedienen der am Autoschlüsselbund hängenden Fernbedienung für mein Garagentor immer etwas fummelig war, wollte ich gerne eine Fernbedienung fest in meinem VW T-Roc (2018) verbauen. Das vorhandene Gehäuse der Hörmann Fernbedienung (siehe Foto) ist dafür allerdings wenig geeignet. 
Als geeigneten Platz für die Fernbedienung habe ich das von mir ohnehin nicht genutzte kleine Ablagefach in der Mittelkonsole identifiziert und dafür ein passendes Gehäuse für die Platine der Fernbedienung konstruiert.

Das Gehäuse ist so bemaßt, dass es ohne zusätzliche Befestigung in der Öffnung des Ablagefachs festklemmt.

Das Gehäuse besteht aus Ober- und Unterteil und der Taste, die zweimal benötigt wird. Die im Original vorhandenen zwei weiteren Tasten rechts und links werden nicht benötigt.  

Für die Verschraubung von Ober und Unterteil habe ich im Oberteil Einschmelzmuttern für M2,5 Schrauben verwendet.  

Benötigt werden zwei Einschmelzmuttern der Größe M2.5 x 3.5 x 3.
 

Tags