1 / 7
Peggit Skadis Clips
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Different Peggit Clips for the Skadis boards
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 27
- Makes
- 0
- Views
- 246
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
These are different versions of the Peggit clip for Ikea Skadis boards.
Multiple variants are available:
- For using with the M4 “Push To Lock” clip: Clip it into the Skadis board and optionally lock it in place by pushing / screwing a M4 DIN 7991 / ISO 10642 flat head screw into the hole, that will prevent the clip from being compressed and thus lock it into place (recommended, similar to the original with the automotive clips).
- Also for using with the “Push To Lock” clip: A T-Lock variant. Push the T-Lock through the “Push To Lock” Clip and turn it with a flat screw driver 90 degree. That will lock the clip into place. The biggest downside is that the whole thing can freely move along the slot up and down. So with load it will sit on the lowest position but if pulling the receiver off upwards the whole clip will move upwards along the slot.
- For using with the M4 Skadis dowel (inspired by https://www.printables.com/model/319281-ikea-skadis-dowel) and a DIN 7991 / ISO 10642 flat head screw
- For using with the M4 Skadis dowel and a DIN 912 socket head screw
- For using with a M2 Skadis Hammer nut from https://www.printables.com/model/807298-skadis-hammermutter-nut
Update 13.09.2024: Added the push to lock variant
Update 13.09.2024: Added the T-Lock variant