Solder Fume Filter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Solder fume filter using two 80mm axial fans. A mount for 1/4" NPT flex coolant pipes allow addition of "helping hands".
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 25
- Makes
- 0
- Views
- 638
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are components that can be used to assemble a powered solder fume filter using two 80mm axial fans. They consist of a dual 80mm fan plenum, a filter box and filer retainer, and a threaded mount for ¼" NPT flexible coolant pipes. The filter box was sized for using some activated charcoal filter pads I had on hand. They were for use with a HAPF30AT filter, and I folded over ⅓ of the length to fit.
To simplify assembly, I glued the filter box base and fan plenum together, but screws could be used. I also glued on the threaded mounts to add four coolant pipe grippers and one coolant pipe LED light ( https://www.prusaprinters.org/prints/96483-helping-hand-led-mount ). The filter sheet retainer presses down on the filter sheet material and is retained by two 3mm screws protruding through the box walls & over the retainer frame.
Both fans and light were powered by a 12v supply via anderson powerpole connectors assembled in the standard amateur radio configuration (red on right with tongues up).
EDIT 12/28/2021: Added part #5, a deflector to be added to the fan exhaust side to redirect exhaust upward.
source materials can be found here: https://www.tinkercad.com/things/jIqTgtupMgm