1 / 3
Knurled pattern planter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
Quite simple yet very cool pot/planter with a nice patern on the outside.
Prints well in PLA/PETG, but should print well using any material on any printer (I Think)
No supports are needed, infill of 8-10% should be sufficient.
In the example pictures I used the Polymaker Polyterra PLA Banana filament.
At 100% the planter is 11 centimetres high, and the hole diameter is approximately 9 cm wide. Scaling the model should not be a problem.