Makita LS1219 Dust Port for Shop Vac
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a replacement adapter for the LS1219 that fits a shop vac instead of the stock 1.5" (40mm) hose.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 82
- Makes
- 0
- Views
- 526
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
This is a replacement dust port for the Makita LS1219 Miter Saw (12"). The stock adapter is sized for a 1.5" (40mm) hose. And the way the stock port is configured, you cannot place the saw up against a wall without pinching the hose.
This replacement is for a standard 2.5" shop vac hose and allows for it to connect to the lower dust shroud providing better air flow and better dust removal. You will also need to print the plug to block off the stock location for the 1.5" hose.
I use it with a standard shop vac elbow to allow the hose to hang down instead of straight back. I did make a previous prototype with a built in elbow, but that needed supports to print, and I had a standard shop vac elbow laying about.
Designed in FreeCAD. I printed with PLA+.
