GTX 1080 FE Design USB Stick (Small)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is the Pendrive Case by Bramesh501, but way smaller. Most normal USB Flashdrives still fit in. I put the USB…
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 127
- Makes
- 0
- Views
- 1,370
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
This is the Pendrive Case by Bramesh501, but way smaller. Most normal USB Flashdrives still fit in. I put the USB stick that comes with the Ultimaker 3 inside and it fits perfectly. I Suggest you check if the USB you want to put in fits. You can also buy the drive I used which is a Verbatim Silver drive: https://www.amazon.com/Verbatim-Metal-Executive-Silver-98749/dp/B017JJSJZM
You'll probably need to sand down the cap to fit in properly if you print with a 0.4 nozzle. I printed again with a 0,25 nozzle and the cap fits perfectly.
This is printable with a FDM printer. You'll need a low layer height for a decent result. I have no experience with resin.
I used Cura to slice the model.
EDIT: The new file (GTX Thumbdrive without holes) has a smooth top surface and is better optimized for printing. The holes and pins are also removed as they have limited purpose and do not print well.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 3
0.25 nozzle, 0.1 layer height
Infill:
I did 20%. Doesn't matter much. 100% would be stronger.
Notes:
I recently printed again with a 0.25 nozzle, the letters on the side are better readable. The top will look better with a lower layer height.
Post-Printing
To finish the Stick, I sanded the pins and the cap to fit. I also sanded the top a little to smooth everything. I painted the Flashdrive Case black, silver/chrome and the letters green. (search gtx 1080 TI for the Original design). Finished painting with a protection coat. Then I glued the the flashdrive inside with a hot glue gun.
Category: Computer