1 / 1
Base reinforcer for 18M fiberglass pole
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A plug for inserting into the base of an 18M push up pole for reinforcement and support.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 114
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I imported some 18m long push up fiberglass masts from China to use as antenna masts and wanted to reinforce the base section and center the mast on a ground spike. This print will slide into the bottom of the mast and prevent any damage to the fiberglass section while allowing a ground spike to slip into the centre.
The outer diameter of the part that slips inside the mast is approximately 68mm.