Apertura AD8 Telescope Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Handle for easier manipulation of Apertura AD8 telescope
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 25
- Makes
- 0
- Views
- 159
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Public Domain
Printed laying flat with supports. I used nylon for extra strength, ability to bend before failure, and heat resistance to leave in a hot car, but my PLA test seemed to work fine too.
Replace two of the M4 screws on the top of the telescope with longer screws pressed through the holes in the handle, may need to use some force with a screwdriver to get the screws through since the tolerance is tight.
The scad model is parametric, so if you have an AD6, AD10, or AD12 you should in theory be able to measure the diameter in mm and set tube_d to that value. I haven't tested it though so proceed with caution.