1 / 13
Low Poly D20 Stand Dice Guardians (Cat, Fox, Dog, Skull) DnD — image 1
1 / 13

Low Poly D20 Stand Dice Guardians (Cat, Fox, Dog, Skull) DnD

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple low poly animals and figures with a spot to put your 22mm (or slightly smaller/bigger) d20.

Rating
0 / 5
Likes
33
Downloads
171
Makes
1
Views
830
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This is set that all started with a low poly cat I made up, that you can fit a regular sized (22mm, give or take a few mm) into securely. It's super cute. You can print it in place on a filament printer, I usually add a brim.

You can print in place on a resin printer if you're good at removing objects without wrecking them. I recommend using supports and braces on a resin printer.

You can print in any colour of filament. Some I do in gray and then paint the model after coating it with Rust-Oleum to prep it. I use acrylic paint (sometimes the same paint in an airbrush thinned down, but my airbrush hates me so I usually do it by hand) and I add a layer of Modge Podge gloss to the top after it's been painted.

I use an Anycubic Kobra 2 Neo.

I have it at a layer height of 0.200 and infill of 15%. I add a 5-15 brim (not necessary, my prints don't stick to my plate very well).

It takes about 1hr 15min (75min) for the cat to print, and the longest is the skull, which is about 2 hours and 10 minutes, to print this and weighs about 16 - 22 grams depending on the filament you use. No supports, just remove it from the plate, it's sturdy and done.