D20 Ice Cube Holder (42mm ice cube, can be resized)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.86 – €5.94 net (excluding VAT)
For file: full size v4.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.40 excluding VAT (range midpoint).
- Weight reported by the author
- 76 g
- Print time reported by the author
- 5 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Put the top and bottom together, pour some water through the hole in the top, freeze it, d20 ice!
- Rating
- 5 / 5
- Likes
- 1
- Downloads
- 37
- Makes
- 1
- Views
- 192
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
I've been working on this for a while now.
This is version 4. I did a test print of version 3 (the files you see) and just needed to add one small thing to it to get the connection between the halves ready, so I did that, and I'll do another print again soon. I scaled it to 75% to save some time and filament.
Anycubic Kobra 2 Neo.
Default Lychee settings for filament.
Print in place. Print on plate.
If you're going to make one of these and use it, you need food safe PLA. There is some out there! It's a bit pricy, but definitely safer. I used colour changing green filament, it goes yellow over 31 degrees C (in light, to touch, heat in its direction) and then back to green as it cools. It was a test, I'm not selling it or making ice out of it (that you know of) so it's fine. :)