Intex pool vacuum nozzle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clean your above ground pool with this nozzle attached to the pool pump and hoses.
- Rating
- 4.5 / 5
- Likes
- 24
- Downloads
- 230
- Makes
- 3
- Views
- 963
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a low cost way to clean leaves and dirt from the bottom of my inflatable pool after a wind storm. This nozzle will connect to the recirculating hose to clean the bottom of the pool. I have an Intex Prism Frame 12'x30" pool for the kids with a 1000 gpm pump/filter. Last year I had an Intex Easy Set 12'x30" inflatable with a 500 gpm pump/filter. I used the connectors to make a longer hose, put the nozzle on the end, blocked one of the outflow connections and cleaned the pool. It sounds harder than it is, but it works very well. Or course, you'll want to replace the filter when you finish cleaning the pool.
The idea came from the shop vac nozzles on Printables and Thingiverse, but I made this one to fit my needs.
Print with default Prusa Slicer settings and brims (I used four loops for stability), no supports necessary, but you can add them if you don't mind the added print time. I printed the round end on the bed with the suction end up. It will barely fit on the bed, but only if you rotate it slightly.