Bambu Lab P1S/P1P side spool holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
side spool holder for Bambu lab P1S/P1P without any extra mechanical components
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 260
- Makes
- 2
- Views
- 1,072
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Introduction
I've recently purchased a Bambu Lab p1s to upgrade from my previous printer (Ender 3v2 with a lot of replaced parts). I have a shelf that I used for the ender and planned on using for the new bambu lab, however I discovered that with the metal spool holder on the back my shelf lacked a little in depth to be enough to fit the printer. I looked for solution and unfortunately everything I saw included additional mechanical components that I do not have. Therefore, I had to quote Thanos and say "fine, I'll do it myself", and here we are.
Required Parts
• Printer connecting part – 1 pc
• Spool holder – 1 pc
• Bolts from the original spool holder – 2 pc
• PTFE tube – comes in the accessories box – 1 pc
Assembly Instructions
- Print the "printer connecting part" and "spool holder".
- Remove the metal spool holder from the printer.
- Use the bolts from the original spool holder to connect the "printer connecting part" to the holes that were used for the metal spool holder.
- Slide the printed "spool holder" in the cut in the "printer connecting part".
- Pull the PTFE tube inside the printer a bit to the extruder to make place for the additional PTFE tube that goes from the spool to the black rubber sleeve.
- Place the second PTFE tube in the sleeve and cut where the filament should get in the tube.
Print Settings
- Printer: Bambu Lab P1S
- Supports: Yes
- Infill: gyroid - 15% at least
- Filament brand: esun
- Filament material: pla+