Gridfinity Nikon Z9 camera body storage bin
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Nikon Z9 camera body storage bin for the Gridfinity system
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 67
- Makes
- 1
- Views
- 679
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Nikon Z9 holder for the gridfinity system. It fits in a 4x2 footprint in a standard gridfinity base. There is recess that will fit a PD Capture clip plate with tethers attached. It will fit other arca plates as well but I haven't tested all of them. The fit is not extremely snug but the bin may pull up from the base if there's nothing securing. There are slots for 6x2mm magnets (x32) as well as M3 screws/bolts (x4) in the base. You would need to use either a skeleton or full base (Fusion360 gridfinity plugin). I'm using the “Light” gridfinity base so I sometimes need to hold the bin down while removing the camera.
This is meant as a companion to my vertical lens holders here and horizontal lens holders here.
I printed these out in both PETG and PLA at .4mm @ .2mm layer height with 10% infill. A .6mm nozzle should be fine too. Feedback and comments welcome!