Scalextric dunlop bridge riser 4 lane extender
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This piece was made to raise up the Scalextric pedestrian bridge to fit over a 4 lane slot car track. There are two…
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 66
- Makes
- 1
- Views
- 332
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This piece was made to raise up the Scalextric pedestrian bridge to fit over a 4 lane slot car track. There are two files, the first is for a color print if you have dual color printer. The taller file is for more clearance.
I would recommend printing in yellow and then coming back with a black or gray primer for the stone work with a light dry brushing on the final parts..
I printed them both a .3 resolution with a 10% infill and it took about 2.25 hours to complete 1 side.
I used http://www.thingiverse.com/thing:30584 for the base, and then made the stairs and sliced off the back to allow the cars to pass.
Instructions
printed fine at .3 with 10% infill. 5mm Brim used to keep it from peeling.
scalextric_dunlop_bridge_riser_4_lane_extender.stl is for a track that is level with the ground that the piece will sit on. for example a routed wood track.
tall_dunlop_bridge_extesion.stl is for tracks tha tsit a few mm higher, for example if you are not using any borders to sit the bridge on.
2_small_brick_scalextric_dunlop_bridge_riser is a tall bridge but made with small detailed bricks.
Category: Hobby