Replacement stand for Harmon Kardon ONYX Studio speaker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
great speaker, legs are the weak point - this works
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 531
- Makes
- 5
- Views
- 1,196
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I used PLA dark wood filament it's good with my older HK ONYX Studio finish.
Print upright as it stands, organic supports result in just some help with the low bridging. Draft mode for printing seemed fine because it's curvy - 15% infill of your choice.
The stand works, holding speaker at about original angle and the woofer cone thing at the back is free to do it's job - important for the ONYX.
You could probably put some foam pad on upper contact points to rule out any plastic to plastic rattle - I haven't yet and it sounds fine at most volumes.
Hope someone can use, glad to share different format if needed.