Mjöllnir
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of https://www.thingiverse.com/thing:1311108 with the following changes: Runes on hammerhead in the original…
- Rating
- 3 / 5
- Likes
- 62
- Downloads
- 321
- Makes
- 3
- Views
- 1,742
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution
Remix of https://www.thingiverse.com/thing:1311108 with the following changes:
- Runes on hammerhead in the original model were not correctly aligned to their corresponding backplate on 3 of the 4 sides, the sides towards the middle of the hammer were not connected to the backplate
- Connectors and connector holes changed to tight fit. If your printer does decent prints the parts are aligned to correct position
All cylindar and conical parts in the handle (and the cylinder on top of the hammer head) are tinkered in Tinkercad to have max amount of sides, this will allow post-processing to start with sanding paper with grit 400 and 600 so no need for coarser ones I strongly recommend printing the hammer head with brim, I didn't and needed some Tamya putty as some of the corners bent up from the print bed during printing
Print Settings
Printer:
Original Prusa i3 MK2S
Rafts:
No
Yes
Resolution:
0.15
20%
Post-Printing
See original model description...
- Connect parts
- Glue together
- Putty where needed
- Instead of primer paint I used XTC-3D to get smooth surface
- Acrylic paints
- Matte lacquer
Category: Props