Replacement Joint Retention Parts For A HUANUO Duel Monitor Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D printed retaining parts designed to replace pieces to a HUANUO Duel Monitor Stand.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 153
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
At my work we had a few monitor stands we wanted to use but were missing some of the parts. The primary structure was there. We were missing the bolts and connectors that keep the arms from coming apart at the joints. My coworker contacted HUANUO, and they were willing to ship us replacement parts but would charge us for them.
The monitor stand in question: https://www.huanuo.com/products/huanuo-dual-stand-32inch-17inch-adjustable-vesa
We managed to get suitable M8 bolts which were left over from TV mounting brackets. I took measurements and designed a the replacement part we needed. Here it is. It consists of the main connector and a washer that goes inside it. We needed a total of 5 per monitor stand: 2 for each monitor arm and one for the laptop holder arm.
Assembly is for each joint simple:
- Insert the main connector with the tab lined up with the slot on the arm
- Place the washer inside the main connector
- Insert the M8 bolt of the correct length and tighten to a moderate level.
Here are the printer settings I used:
Slicer: Cura 5.6
Initial Layer Height: 0.3mm
Layer Height: 0.2mm
Infill: 20% Cubic
Wall, Top, & Bottom Thickness: 1.2mm
Supports: Yes - Normal
Adhesion: Brim
Material: Overture PLA Plus Gray
Extruder Temp: 210 C
Bed Temp: 60 C
Total Filament Used: 10 grams for Each Connector & Washer Set
Notes:
This project was designed in Onshape under a maker account. Per the terms of the account, this design cannot be commercially used. To learn about using Onshape, I recommend this series by Teaching Tech.