Divider for Ikea ORDNING utensils holder
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.63 – €3.22 net (excluding VAT)
For file: 2 Perimeters, skip the infill and shorten it to 131mm makes it a quick print / divider_03mm_pet_mk3s_2h26m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.92 excluding VAT (range midpoint).
- Weight reported by the author
- 50 g
- Print time reported by the author
- 2.44 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
I don't like to throw all of my utensils into one big container, so I've designed this internal divider for the Ikea…
- Rating
- 4.872 / 5
- Likes
- 828
- Downloads
- 1,910
- Makes
- 45
- Views
- 8,523
- Reviews
- 39
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
I don't like to throw all of my utensils into one big container, so I've designed this internal divider for the Ikea ORDNING utensils holder.
It's designed to snap into place (the upper part has a lip that grips the edge). There's also a "peg" at the bottom that goes into the center hole and prevents any movement.
This was designed for the smaller Ordning holder which is 13cm tall. It should be held firmly in place once you snap it in, but I've noticed that some containers are slightly oversized, which might not create a tight fit.
Print instructions
No supports needed, print with the large circle/edge touching the bed.