1 / 3
EDC Screwdriver+magnetic bit holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Has a 10 cm ruler and place for storing 10 hex bits.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 28
- Makes
- 0
- Views
- 205
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print at 0.15mm layer height with a 5mm brim. The U shaped pin attaches to the back and stays in place with the clip. The purpose of the pin is to remove the bits by pushing them out since they are completely integrated in the handle.
You will need 6 Neodymium magnets (20x8x1.5mm) which you push in from the side of the print .
The small marks on the ruler are every 2mm and the big marks every 10mm.