Incra TS-LS Fence Alignment for Sawstop
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two of these fit tight in the miter slot on the Sawstop makes quick work of squaring the TS/LS fence to the miter slot.
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 124
- Makes
- 0
- Views
- 588
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
I have to flip my TS/LS fence whenever I move from table saw to router mode. It's not an exact science, so I always square the fence to the miter slot each time I reset the fence for use with the table saw. I have used the Woodpecker alignment dial in the past, and it can be a bit time consuming. Since these have a nice tight fit in the miter slot, and come to points, I just have to loosen the housing screws, push the fence up to the adjusting stops, tighten down the screws, and I'm perfectly aligned.