Boosted Tow
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
A tow hook for the boosted board. I made this because while dragging the boosted board by it's rear trucks, the board would occasionally nose drag (especially for taller people). This device lowers the board and prevents that. Make sure to only have it attached while the board is off and only use it to pull the board in an off state. I am not responsible for property damage or injury to yourself or others while using this device.
It snaps under the rear trucks and held in place between the skid plates. I used a clothesline rope to attach the two parts. The handle is designed to fit in the hooks for storage (see pic). I've also made models for both the v2 boosted board, and v3 boosted board. Be sure to print the right one for your board along with the corresponding handle so it fits between the hooks.
Print Settings
Printer:
BIBO2
Rafts:
No
Yes
Resolution:
.2 layer height
20%
Filament: 3D Solutech PLA blue and black
Notes:
Print the harness on it's side with supports to hold up the other side of the hook.
Feed a length of rope through both pieces and secure with an over hand or figure 8 knot.
Category: Hobby