Raspberry Pi Zero (2) W Mount for Original Prusa i3 MK3S+ [40 mm Pin Version]
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quick remix of Zbigniew Trzepizur's model to support 40 mm pin header
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 38
- Makes
- 1
- Views
- 364
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
All credit to Zbigniew Trzepizur. This remix supports 40 mm pin headers (instead of 37.8mm) and uses 16 mm M3 (M3x16) screws instead of 14 mm.
uxcell 40 mm pin header: https://www.amazon.com/dp/B07DXQ1K4B/
There are two plastic shrouds on these header strips offset at different distances from the pin ends (3 and 6 mm). The 3 mm side will be soldered to the board. Prepare the 5-pin header appropriately, per: https://help.prusa3d.com/guide/prusalink-and-prusa-connect-setup-mk3-s-_221744.
You can remove the other shroud on the 6 mm side before or after soldering, but I suggest removing the extra pins using needle nose pliers while both shrouds are still attached, then remove the extra shroud after soldering.