Comgrow/Sovol SH02 Dryer Filament Guide Fix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fix for the sharp angle inside the dryer box. Helps eliminate spool jams.
- Rating
- 4.889 / 5
- Likes
- 91
- Downloads
- 588
- Makes
- 10
- Views
- 4,065
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a fix to the sharp angle in the Comgrow/Sovol SH02 Filament Dryer Box. The factory guide would cause excess bends and jams causing failed prints unable to pull form the box. This puts it more of a vertical instead of a parallel feed function eliminating the strain.
Uses the factory screw, nut, and rubber seal to maintain air tight.
Print with high temp filament such as ABS/ASA because the inside does get up to 70C. PETG/PLA+ might be OK. No guarantee.
Can insert a PTFE tube on both sides or not. The inside hole is beveled so no sharp edges.
No supports needed! Print with the threads facing up!