1 / 8
Swings,yet doesn't fall
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
For this model, which cannot be dropped by shaking, 1.75mm filament cut from the spool was used for the hair, inside of the eyes and mouth. To curl the hair, you should keep the filament on the hot printer table for a while to soften it. The filaments should be placed and the excess should be cut off. Inside the bottom part, you need to glue 2 10 cents, which is necessary for the weight (there is also room for small coins for those who use different currencies. It must be at least 9gr. PLA was used, 0.20mm layer. Support is required.