1 / 10
Kobra 3  Netzteildeckel Lüfter / Power supply cover Fan — image 1
1 / 10

Kobra 3 Netzteildeckel Lüfter / Power supply cover Fan

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Deckel für Netzteil mit leisem Lüfter Cover for power supply unit with quiet fan

Rating
5 / 5
Likes
56
Downloads
216
Makes
2
Views
1,476
Reviews
4

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Deckel für Netzteil mit leisen Lüftern

Der Unterschied ist enorm, die Lüfter kaum noch hörbar.

Umrüstung auf 12V Lüfter 

Schritt 1:

Ausbauen des Original Lüfters

Schritt 2:

Step Down Modul auf 12V einstellen . BEIDE !!! Lüfter mit dem StepDown Modul 12V vekabeln

Schritt 3: 

Lüfter in das neue Gehäuse einbauen 

  • Originallüfter bläst in das Gehäuse
  • 80mm Lüfter aus dem Gehäuse

Schritt 4:

Distanzstücke für die Füße anbringen

Mittelsteg anbringen (damit die warme Luft nicht gleich vom Originallüfter wieder angesaugt wird)

Schritt 5:

Abdeckung am Netzteil anbringen

 

Material: Jayo PLA schwarz matt
Support: nein
Schichthöhe : 0.24mm

 

-------------------------------------------------

Cover for power supply unit with quiet fans

The difference is enormous, the fans are barely audible.

Conversion to 12V fan 

1x Original Anycubic power supply fan
1x AAbCooling Slim Silent Lüfter 80mm x 10mm ( https://www.amazon.de/dp/B01HTJ78LI?ref=ppx_yo2ov_dt_b_fed_asin_title )
1x DollaTek MP1584EN Stepdown Modul  ( https://www.amazon.de/dp/B07DJ5HZ7G?ref=ppx_yo2ov_dt_b_fed_asin_title )

Step 1:

Removing the original fan

Step 2:

Set step down module to 12V . BOTH !!! Cable the fan with the StepDown module 12V

Step 3:

Install the fan in the new housing

Original fan blows into the housing
80mm fan out of the housing

Step 4:

Attach spacers for the feet

Attach the center bar (so that the warm air is not immediately sucked in again by the original fan)

Step 5:

Attach the cover to the power supply unit

Translated with DeepL.com (free version)

 

Material: Jayo PLA black matt
Support: no
Layer height : 0.24mm

 

Tags