Torsion bar rear suspension for 1/12 RC CAR
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a trailing arm independent rear suspension. The coil is replaced by a torsion bar.
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 87
- Makes
- 0
- Views
- 631
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial
This is one of my proof of concept designs for the rear axle.
(I'll be using a McPherson strut suspension for the front axle)
First of all this is NOT the rear suspension of most of the current cars which is a torsion BEAM suspension (I plan to design that one too…) The inspiration for this model comes from older cars (ca 1980). The goal here was (I think) to have a more compact assembly and eliminate the coils. It uses 2 torsion BARS. However it looks that later on the torsion beam suspension prevailed.
This is still work in progress (tuning needed) and a simplified version (no anti-roll bar, no ball bearing for the suspension arm etc…) But due to the fact that we are making this out of plastic let's not over-engineer the thing !
How does this work ?
The PLA spring (PETG is better for flexing but PLA works reasonably) is replacing the dampener that is usually used in rear suspensions. The 2 octagonal torsion beams replace the coils that define the static position of the wheels; they connect one of the suspensions arms to the main beam on the opposite side (in fact it's the suspension brackets - but this is a rigid assembly) . On real torsion bars, you have 2 spline gears that are shifted one vs the other so you can make fine tuning increase or decrease the height of the car etc…)
So in this design the torsion bars determine the height of the rear of the car.
Used alone, they do provide some suspension when they twist along their length… Well PLA being brittle - let's put some PETG to be safe for the torsion bars.
Normally you should mount the torsion bars first and measure the distance between the holes intended for the spring/ dampener (which should be ca 35 mm). This gives the initial angle between the main bar and the suspension arms.
In our case we will put the springs first which will give the right angle (when not loaded), and then the torsion bars as they fit.
The brackets mount to the chassis (to come). I use M3 screws and for each wheel axe there is a MR117 ball bearing (10x7x3).
Printing: some parts are symmetric but some are not; usually the part's name should help !
I'm providing a PLA print file; you can print a few parts in PETG (torsion bars + springs)