Heltec WiFi LoRa 32(V3) Command Center
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Heltec WiFi LoRa 32(V3) Command Center
This is a 3D printed case for the Heltec V3 WiFi LoRa 32 dev-board commonly used for Meshtastic. This extra-large case was designed to be versatile, rugged and have ample space inside for whatever you may want to do. Interior dimensions are approximately 80mm x 90mm and large enough to hold 4 18650 Cells (not inside of battery holders).
The case includes a power switch on the front face. The front face is angled at 45° and has 2 small holes to view the charging indicator and message LEDs on the Heltec V3 board.
If you want to tinker this is the case for you. There are 3 openings on the case that will all fit an SMA connecter for attachment of an antenna or cable and all SMA openings have supports to keep the connector from spinning, The openings can be used for other purposes as well (power, external GPS antenna, etc). The case comes with 3 plugs to block off any unused antenna/cable port opentings.
Plenty or room for GPS module and antenna. And since case is easily taken apart and put back together using screws, no worries of clips to wear or break.