Bar Clamp Couplers. Irwin and Harbor Freight
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Couple two bar clamps together for longer reach. May fit other brands, Bar dimensions given below.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 67
- Makes
- 0
- Views
- 309
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
These couplers are printed on the narrow side down letting the plastic span across without using supports and giving linear strength. Like nearly any coupler, there will be a certain amount of bowing at the connection. These couplers fit very tight to the point of needing a mallet to install. This helps reduce bowing. I was able to use the actual screw fasteners on the HFT clamps but needed screws for the Irwin. To remove coupler, take out screws, put clamps over object and squeeze handle. It will pull one side off. Using a block of wood between trigger head and coupler will also work.
HFT 4inch - 3mm x 8mm bar - wall line count 4, 100% infill
HFT 12 and 18inch - 6mm x 16mm bar - wall line count 4, 50% infill
Irwin 6inch - 5mm x 13mm bar - wall line count 4, 50% infill