Spinner CAF N Connector 1/2" Hardline Jacket Cutting Tool
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tool to get the 25 mm cut perfect for installing Spinner CAF N-connectors on 1/2" hardline cable.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 80
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A simple tool to get the 25 mm cut perfect for installing Spinner CAF N-connectors on 1/2" hardline cable. This should work on any hardline cable, such as RFA-½, Andrew Heliax etc.
Depending on the connector, Spinner connectors require you to peel back the outer insulation a certain amount. For N-type connectors on ½" hardline, that amount is exactly 25mm. This tool allows you to get that cut exactly 25mm back without risking cutting into the corrugated copper shield of the cable; with a blade inserted firmly into the slot and the end of the cable up against the end stop, it should cut approximately halfway through the insulation, creating enough of a fault line for you to be able to peel off the rather hard outer jacket.
Precision isn't critical on this cut, but the tool greatly speeds up installation.
Print with the text down on the print bed and use supports; that way, the layer lines are oriented so that you can't cut through them easily by mistake.