Bambulab Desicant holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It was time to replace the desicant in my Bambulab P1P. I always use Dry & Dry desicant when I need desicant so I made…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 19
- Makes
- 0
- Views
- 261
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
It was time to replace the desicant in my Bambulab P1P. I always use Dry & Dry desicant when I need desicant so I made a easily refillable holder for my P1P. You can use the original cover and attach it to the base with a 1.7x5 mm screw or you can print you own cover.
I tried printing a cover with a latch but found it was difficult to get a reliable working latch, I may work on it in the future.
A photo shows how to put it on the bed and print it.
The original cover is what I prefer because it latches down and you don't have to worry about it rubbing on the spools. There is only a few mm's clearance so you have to have it flush with the bottom. The unfortunate thing is the Bambulab cover has holes that allow the smaller pellets to pass through. I found that when you assemble it just put a coffee filter under the cover before you screw it on. You only have to do that once as it refills from the rear with about 1 1/2 oz's of desicant.
If you print the cover and make a complete assembly you may need to trim it a little to make sure it sits flush when it's inserted.
The Dry and Dry desicant can be dryed in 10 minutes in a microwave and reused, just follow their instructions. You may be able to put the whole module in a microwave if you keep the power low enough. Defrost cycle seems safe but I tried just the pla on high power and it melted so try it without the bambulab cover first to make sure your safe.
I hope you find it useful or at least give you and idea on how to make one better.
Cheers Kisssys
Category: 3D Printer Accessories