1 / 1
investigation of salt annealing of transparent pla parts chapter I — image 1

investigation of salt annealing of transparent pla parts chapter I

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Hi everybody, After having see the video from Stefan CNC Kitchen Here belowhttps://www.cnckitchen.com/blog/testing-…

Rating
0 / 5
Likes
5
Downloads
7
Makes
0
Views
415
Reviews
0

Updated at source:

Model information

Category
Test Models
License
Creative Commons — Public Domain

Hi everybody,

After having see the video from Stefan CNC Kitchen
Here below
https://www.cnckitchen.com/blog/testing-the-strength-of-3d-prints-re-melted-in-salt
Also he did a re sintering in plaster in an early attempt, another did a previous work with salt and a clear filament
https://hackaday.com/2020/09/23/reforming-3d-prints-with-salt-and-heat/

Both works are great.

I tried to get transparent pla 3d printed parts from a m3d printer and a poor quality pla filament.
But nevertheless for the trial a good way to go.

I exchanged some mails with stefan from cnc kitchen which push me to keep on.
Thanks a lot to both of them for pioneering and showing me the way.

So first I tried to print a calibration dice with a high infill as 100 pct was not possible... I found a way afterwards: setting skin number sothat it cannot print any infill. So i put 20 skin counts... just in case if somebody is struggling with this too.

Once printed, I used salt and a kitchen shredder to get finer salt particles, used a sieve to select only the smallest particles portion. Then I use a glass container, filled a bit with salt about 1 cm pressed with a part just little smaller than the container, then layed down the dice and filled from the middle in order to recover the dice with 1 cm of salt. Then pressed the salt again with the dice inside.

I put this at 200C. For 2 hours then take out the oven let it cool for 15 min then take the salt away...
And I got the frosty wall effect as mentioned already.
And look at the dice ... they did not maintain shape (here it was really bad but later much better)

From there I thought ok what can be done to get transparency? Salt particles are kind of stamped on the surface leaving this look...
But is it really only a mold effect or does it react with the pla?
I have not the answer yet.

I worked on some solutions watch chapter II which comes at some point.

NOTA first scorchcad android I made as dummy stl for the fun ... as nothing can be published without a stl...

Category: 3D Printing Tests

Tags