Amig dehumidifier replacement cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
May fit other dehumidifiers as well
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 68
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The drain connection is a strange screw thread between 16 and 17mm. After about 10 attempts, I found the correct thread and designed this replacement drain cap. There are two pieces: the cap itself can be printed in just about anything (I used PETG). The washer should be printed in TPU or other flexible filament.
The washer is a tight fit into the cap, but not too difficult. I ran the dehumidifier with the replacement drain cap for about an hour without any leak.
Here is an adapter to 19mm garden hose: https://www.printables.com/model/1050628-amig-dehumidifier-drain-adapter-to-19mm-hose