ScrubDaddy Holder for sink w/Lip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hold your Scrub Daddy and drain into your sink with parametric values for a ledge.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 27
- Makes
- 0
- Views
- 315
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Share Alike
I saw the various holders and none could be easily adapted to fit my sink lip so I modeled one with parametric values for a ledge. I have included the fusion files and all you need to do is change the parameters to suit your needs. I currently have them set at the minimum values before funky things happen but if you increase them it should adjust just fine. This includes the front lip height, the rear height and the gap between them, since the front lip is more defined it should only grow the distance backward from there as you increase the gap.
Print settings: I would use at least 4 walls to try and keep water out but infill can be left pretty low, 15%, unless you need it to be more weighted. The 3mf shows the correct print orientation on its backside. Supports for the front lip will probably be needed, I suggest Normal Snug supports, and mouse ears can help if you find it curling up with higher infill settings