1 / 8
Dual MagSafe iPhone Standby Mode Dock Parametric
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dual-Magsafe version. Made for iPhone 14 with a thin case. Fusion files included with parametric dimentions
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 129
- Makes
- 2
- Views
- 2,283
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
Important Notes: Measure your Magsafe charger and adjust the dimentions in Fusion accordingly. I used knock-off Magsafe chargers (do not recomend, they get really hot) and based dimentions around those.
Phone dimentions are based off of an iPhone 14 with a case so adjust those as well.
Non-printed parts:
| Part | Quantity | Link |
| Magsafe Charger | 2 | https://www.apple.com/ca/shop/product/MX6X3AM/A/magsafe-charger-1m |
| 12 mm Rubber Feet | 4 | https://www.amazon.ca/Adhesive-Furniture-Bumpers-Cabinets-AUSTOR/dp/B074C2XKXH/ref=sr_1_5?sr=8-5 |
Printing Instructions:
- Orient all parts as shown in the later images
- Main dock requires support, set support angle to 60 degrees and use tree supports. Make sure supports are not being added to the recesses for rubber feet of the main dock.
- “stopper” part should be scaled down to around 95% or else it will be a tight fit.
Assembly:
- Install the front Magsafe charger in the usual method, the fit might be loose so either adjust the dimentions in Fusion or use some double-sided tape to secure the charger.
- Insert the Magsafe charger into the rear compartment with the wire facing towards the front.
- Once the rear charger is all the way inserted, push it backwards to secure it in place.
- Insert the “stopper” into the gap at the front of the rear charger hole to secure the rear charger.
- Thread the cable thru the provided hole out the back.