1 / 4
Snap Fit Raspberry Pi 5 Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A printable case for your rasberry pi.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 145
- Makes
- 0
- Views
- 868
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
There are two variants of the bottom part:
- M2.5 Hex Nuts: This variant is for use with M2.5 studs or 6mm screws to secure the raspberry pi to the bottom part.
- Printed Studs: This variant allows for tool-less install of the raspberry pi to the bottom part.
Print settings:
- 0.2mm layer height
- 0.45mm line width
- 15% infill
- 3 perimeters
- NO supports needed