1 / 8
Motorola Advisor TPG2200 Homestation for EspHome — image 1
1 / 8

Motorola Advisor TPG2200 Homestation for EspHome

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

a remix of a Motorola Advisor TPG2200 Homestation designed to house a D1 Mini for EspHome compatibility

Rating
5 / 5
Likes
14
Downloads
119
Makes
1
Views
861
Reviews
1

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial — Share Alike

A remix of a Motorola Advisor TPG2200 Homestation designed to house a D1 Mini microcontroller for esphome compatibility for homeassistant. This allows you to craft all sorts of smart home automations via homeassistant when you get an alarm on the pager.

You will need a instance of homeassistant and ESPhome running and some basic configuration knowledge with this version! If you dont want that please use the original version using a shelly.

In comparison to the original model there is no need for wago clamps, an additional power supply/cable or an expensive shelly anymore. Wiring is also way simpler this way. 

you can find the contents of my ESPhome-configuration .YAML file attached below for reference

Printed parts

  • V1: as shown in the pictures, original version - supports needed
  • V2: improved printability on bottom part - printing without supports possible

BOM

  • ferrules included with the homestation
  • 2x 10cm of ~0,25 mm² wire (or jumper cables)
  • D1 Mini Microcontroller, I used this one
  • this USB-splitter cable to provide power to the homestation and the D1 Mini

Wiring

  • when using my config: crimp the ferrules onto the two wires and plug them into the station; solder the other ends to Pin D4 and GND respectively
  • plug in the Micro-USB cable coming from the splitter into the D1 mini
  • plug in the Type-C cable from the splitter into the home station

Tags