Fountain Style Lawn/Garden Sprinkler
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A lawn/garden sprinkler with no moving parts.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 31
- Makes
- 0
- Views
- 570
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print these two parts in either PETG or better yet ASA. In addition to the two printed parts you will need (1) one 54mm OD x2mm thick O-ring, (2) four 10-24 x .625 FH screws and (3) three 3 x 100mm steel or aluminum dowel pins. The thread on the base is garden variety (no pun intended) 1-11.5 GH. Recommended garden hose is a 5/8" which is coupled to the device via a 2" long F-F “lead-in” hose. Depending on the size of the printed dowel pin holes you can either press fit the pins (may have to slightly open the holes post-printing - do not drill through the bosses) or Loctite them in place. You want them securely in place to facilitate moving the device around in your yard from place to place. The four screw holes should be .1495 +-.002 inches prior to tapping them with a 10-24UNC-2B tap. The irrigated area will be approximately 20' in diameter with a water pressure of 38 psig.