Oculus Quest 2 Controller Handstrap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Better Handstraps for the Quest 2
I Printet the little Inserts on my Anycubic Photon Mono in Clear Resin
and The Stretcher on my Anycubic I3 Mega in Procatc Signal Red
The Stretcher is designed for 20mm Belt, I used a 20mm x 0,5 mm Belt.
To attach the Belt to the Insert cut a indentation on both Sides (Picture 11)
than Insert it in the Insert (Picture 7) and thread it through the Stretcher (Picture 8,9),
it shoud look like in Picture 10, thread it further through the Controller and again through the Stretcher, tie it around the top of the stretcher.
The Stretcher is Originaly from GigaBajcior of Thingiverse www.thingiverse.com/thing:1001682 i modifyd it to use for my Belts.