Soap Scoop (no supports needed)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.61 – €0.74 net (excluding VAT)
For file: soap-scoop_0.4n_0.2mm_PLA_MK4IS_33m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.67 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 33 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Scoop for Dishwasher Soap Powder 25ml/parametrized (no supports needed)
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 59
- Makes
- 0
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- GNU General Public License v3.0
A simple scoop for dishwasher soap powder. The default version scoops about 25ml (25cm^3, 0.85oz, about 1 shot of gin in England) or the amount a normal dish washer needs.
Simply print it with the opening towards the print bed and the handle flat on the bed. No supports should be needed in this case, since angles are about 45°. PLA and standard parameters will be fine unless you want to scoop something very different from dishwasher soap.
Changing Parameters
Open the FCstd file in FreeCAD 0.21 (stable) and open the internal spreadsheet. Adjustable parameters are on the left side of the table, calculations on the right. The calculated volume is visible in the “Total Volume” cell (green background). Simply adjust the parameters gradually and watch the volume calculation until you get close to your desired value. Don't try to aim for an exact match - scoops are very imprecise anyway.
When done, double check that FreeCAD did not freak out and lose its calculations. Then mark the blue “Body” in the hierarchy and export it as an STL file ("File" menu → “Export…”).