Spartan SR Trim Tabs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A few sets of trim tabs at various degrees below the keel of the boat.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 50
- Makes
- 0
- Views
- 247
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
A couple of sets of trim tabs for the Spartan SR. That will enhance the stability of the boat of high speeds. There are sets for 0, 2, and 4 degrees below the keel of the boat. You can mix and match as needed for your boat setup. I have had good success with the 0 or 2 degree set of trim tabs installed.
If you choose to install the full set of trim tabs you will need to drill out the outer holes of the hull for the trim tabs closest to the drive shaft. Use a hand drill to pierce the outer hull of the Spartan SR. There are mounts on the inside of the hull, they simply need to be exposed. Once these holes are drilled you will have a full set of 4 trim tabs on your Spartan SR.