Razer Wolverine V3 under desk controller holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Under the desk controller holder for the wolverine v3, with a hole for the USB C to go through.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 89
- Makes
- 0
- Views
- 1,014
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Kind of just made it for myself and thought I would share if anyone wants. This is most likely not the finished model but it works so I'll run with this till I have time to make it better. Feel free to make adjustments. It's not as snug as i want it to be so that will be changed for sure.
This should work on the wolverine v3 pro as I'm pretty sure they're the same shape. I could be wrong though.
Only for the the v3 does not work for other lines of controllers including the older v2
I'd recommend printing it using the 3mf provided as this is how i printed it but whatever works best for you.
layer height: 0.32mm (do whatever you feel is best I just wanted a quick print) ;
Infill: 15%;
Supports: if you keep it to the 15 deg tilt on the bottom piece then yes. And yes for the top piece;
Brim: again if you do 15 deg tilt on bottom piece then yes for that piece;
pretty simple to put together, the two pieces slot into each other (0.2mm tolerance named gap for hole in solidworks file)
then the little square piece goes into the bottom hole to make sure it stays in place ( this has a 0.15 tolerance to be extra tight (lost in file but dimensions are 5.7mm X 8.7mm X 12mm))
might be quite tight so use something heavy to kind of bang it in, this is just so it is stuck there, I used a rolling pin on mine haha.
it uses m2 screws but can be adjusted for different screws
in the solid works file you can adjust the angle and a few other things like the height etc. you may have to look a little bit though, I'm sorry I'm extremely messy.