Reinforced super save bike wall mount with diffrent tyre carrier sizes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A special version for reinforced bike wall mount with super safe hook for SPD pedals. Tested with Shimano M520 pedal.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 97
- Makes
- 0
- Views
- 564
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A special version for reinforced bike wall mount with special hook for SPD pedals. Tested with Shimano M520 pedals.
I tested a other 3D design but my bike fall out of the mount and got damaged. Therefore I designed a super strong pedal hook which holds my bike save in position (tested over 2 years period without fail)
There are also three different sizes of wheel carriers available:
- Wheel_carrier_28mm_Race_Bike → up to 1.1" tyres
- Wheel_carrier_45mm_Gravel_Bike → up to 1.7" tyres
- Wheel_carrier_60mm_Dirt_Bike → up to 2,4" tyres
The design is inspired by commercial available bike wall mounts. The pedal hook is special designed, that it can be easily printed and reliably holds the bike in place with a slight angle.
The bike seems to fly in the air in front of a white wall if printed with pure white PLA filament.
Mounting Instructions:
Use 4 mm screws with sufficient length in combination with dowel.
- Mount the two wheel carrier to the wall on the same height level.
The space between carriers should matching to your bike wheel distance. Therefor just measure the touching point of your bike when it stands on the floor. - Place your bike on the mounted wheel carriers and hold the pedal hook clipped in upper position on the pedal and mark the holes to drill
- Drill the holes for the hook and mount it.