Magnetic Boveda Humidity Pack Holder for Humidor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Magnetic Dual Boveda Humidity Pack Holder for Humidor. No supports.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 49
- Makes
- 0
- Views
- 401
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This design was based on the OEM Boveda cedar humidity pack holder. The issue with the original model is that if you recharge your Boveda packs with distilled water, the packs swell a bit and don't easily fit back into the OEM holder. This design has a bit more room.
This holder prints with no supports and has insert holes for 10mm x 3 magnets. You can drill and glue corresponding magnets to the lid of your humidor, or glue a metal plate into the lid of your humidor.
There's also a feature where you can insert 6mm x 3 magnets into the front of the holder and mount a hygrometer to the front (as shown in the photo) using the magnetic hygrometer mount by @MakerMethod_1340578.
Print without supports with 10mm brim. I used PETG, but any material should be fine.