K1 4010 Bed Fans - The No Extra Parts Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
No need for extra hardware!
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 130
- Makes
- 1
- Views
- 1,003
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Booty made a great mod, but it makes use of a lot of extra hardware (bolts, heatset inserts, etc) that I felt was just unnecessary.
Now, the only hardware used are the screws already attached to the printer. No need for additional screws, inserts, etc. Clips were added to hold the fans in place, but the only issue is that they're pretty difficult to remove once installed. Because of this, the right side requires a bit of special care. You must thread the cable through the underside first, then attach the duct to the bed, and THEN clip the fan in. After this, you can pull the wire to remove slack.
Infill doesn't matter, I used 20% gyroid. Tree support is optional but recommended. Use ABS/ASA/PC/PA - Don't use PLA or PETG!!
As always, .step files are included. Feedback is welcome, and happy printing :3