Bit holder for hexagon screw bits
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.43 – €0.53 net (excluding VAT)
For file: bithalter_nz0.6_3x5_0.6n_0.3mm_PETG_MK3S_22m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.48 excluding VAT (range midpoint).
- Weight reported by the author
- 9 g
- Print time reported by the author
- 22.2 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Bit holder for hexagon screw bits, printed in spiral vase mode.
- Rating
- 4.875 / 5
- Likes
- 122
- Downloads
- 772
- Makes
- 9
- Views
- 3,174
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bit holder for hexagon screw bits
New version available: Klick here
Of course, there are already different bit holders here. The special thing about this one is that you only need very little filament to print it, and the printing is very fast because the bit holder is printed in vase mode. In addition, the bits are clamped, and can not fall out.
Printing instruction
Due to the vase mode, the extrusion width must be taken into account in the dimensions. Therefore the models are available for the standard 0.4 mm nozzle (*nz0.4*), and for a 0.6 mm nozzle (*nz0.6*). You can also print the models for nz0.6 with the standard nozzle, but then you have to set the extrusion width to 0.65 mm.
Deviating from the standard profile:
- activate spiral vase
- Increase Solid Layers Bottom by 1 (the bottom plate is 1.4 mm thick)
- 0.3 mm layer height
To find out if the tolerance fits without wasting filament, I recommend printing the 2x2 version first. If the bits are too loose or too tight, you can scale in X and Y.
Tested with PETG. I would not use PLA. G-Code is done with Prusaslicer 2.4