Stomp Rocket Jr. Rocket Launcher Leg
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement leg for a Stomp Rocket Jr. kids rocket launcher. Print three of them for a complete set.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 39
- Makes
- 0
- Views
- 184
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These legs are a little bit sturdier than the original, and the round foot means that the legs don't all have to be in the same position for the rocket launcher to sit flat – great for launching on hills or uneven ground!
Printed in Overture Super PLA+ on a .4mm nozzle and .2mm layer height. I found the best orientation for this part to be on its side with automatic supports (snug). Each leg should only take ~25g of filament for a total of ~75g for a set of 3.
I highly recommend printing just the top part and doing a test fit before printing the full leg. The tolerances aren't terribly tight, but a bit of overextrusion may prevent it from fitting properly.
Here's the original Onshape document in case you want/need to make any changes.
https://cad.onshape.com/documents/724f6e813b3e8edeb0b619a3/w/f9b7e0238868d992979b5cfa/e/e57f01f911f97dbdae5377db