Clip-on Flysky I6/I6X gimbal and Switch Protector
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.62 – €4.43 net (excluding VAT)
For file: FlySky I6X gimbal protector / aa8_clip-on_flysky_i6x_gimbal_and_switch_protector_v11.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.02 excluding VAT (range midpoint).
- Weight reported by the author
- 30 g
- Print time reported by the author
- 5 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a gimbal and switch protector the the Flysky FS-I6X Transmitter. It clips on where the lanyard would go. It…
- Rating
- 5 / 5
- Likes
- 54
- Downloads
- 684
- Makes
- 13
- Views
- 2,152
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
This is a gimbal and switch protector the the Flysky FS-I6X Transmitter. It clips on where the lanyard would go. It may work with the Flysky FS-I6 but I don't have a transmitter to test it on. If someone prints it for the I6 and it fits please leave a comment. This design was inspired by spudinator after making a protector that included switches. I still wanted more protection so I created this one with full covers and also wanted it to clip-on.
Edit 5-2-18: This does work with the FS-i6 as well, Thanks jos310581 for checking.
Edit 5-4-18: Added version without tops for easier printing and also uploaded a STEP file for easier editing if people want to customize.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Mk2
No
Supports:
Yes
0.2 mm Layer Height
Infill:
20%
Notes:
After printing I used a heat gun to bend the switch covers into place. I also used the heat gun to fit everything a little better to the controller. You can also use the heat gun to adjust the clip-on part to make it more snug if you prefer. Don't be heating it up while its on the transmitter either!rnrnPrinted Material: PLArnI will probably re-print this in PETG because I will know this will be sitting in my car and I don't want to worry about the the protector warping on a hot day.rnrn
Category: R/C Vehicles